ConnectGear WA660N - Manual (Page 43)

36
If you select 2.4GHz (B+G), then only wireless
clients using 802.11b and 802.11g band will be
able to connect to this access point.
If you want to allow 802.11b, 802.11g, and 802.11
Draft-N clients to connect to this access point,
select 2.4GHz (B+G+N).
MAIN ESSID Please input the ESSID (the name used to identify
this wireless access point) here. You can input up
to 32 alphanumerical characters. PLEASE NOTE
THAT ESSID IS CASE SENSITIVE.
Multiple ESSID The access point supports multiple SSID function;
up to four SSIDs can be set. If you want to
configure additional SSIDs, please click this
button. For detailed descriptions of the function,
please refer to Section 2-4-1-1.
Channel Number Please select a channel number you wish to use.
The channel number must be same with another
wireless access point you wish to connect
Associated Clients Click ‘Show Active Clients’ button and a new
popup window will appear which contains the
information about all wireless clients connected to
this access point. You can click ‘Refresh’ button in
popup window to keep information up-to-date.
MAC address 1-4 Please input the MAC address of the wireless
access point you wish to connect
Set Security Click this button to select an encryption mode for
this wireless link, a new popup window will
appear. Please refer to Section 2-7 for detailed
descriptions.
After you finish with setting, please click ‘Apply’, and the following
message will be displayed: