ConnectGear WA660N - Manual (Page 49)

42
Authentication Mode: The wireless security
authentication mode of this access point will be
displayed here. If you don’t enable security
function of the access point before WPS is
activated, the access point will auto set the security
to WPA (AES) and generate a set of passphrase key
for WPS connection.
Passphrase Key: Displays the WPA passphrase
here, all characters will be replaced by asterisk for
security reason. If encryption is not set on this
access point, nothing will be displayed here.
Config Mode There are ‘Registrar’ and ‘Enrollee’ modes for the
WPS connection. When ‘Registrar’ is enabled, the
wireless clients will follow the access point’s
wireless settings for WPS connection. When
‘Enrolle’ mode is enabled, the access point will
follow the wireless settings of wireless client for
WPS connection.
Start PBC Click ‘Start PBC’ to start Push-Button style WPS
setup procedure. This access point will wait for
WPS requests from wireless clients for 2 minutes.
The ‘WLAN’ LED on the access point will be
steady on for 2 minutes when this access point is
waiting for incoming WPS request.
Start PIN Please input the PIN code of the wireless client
you via client wish to connect, and click ‘Start PIN’
button. The ‘WLAN’ LED on the access point will
be steady on when this access point is waiting for
incoming WPS request.
NOTE: When you’re using PBC type WPS setup, you must press
‘PBC’ button (hardware or software) of wireless client within 120
seconds; if you didn’t press PBC button of wireless client within
this time period, please press ‘PBC’ button (hardware or software)
of this access point again.