ConnectGear WA660N - Manual (Page 62)

55
2-7-5 802.1x Authentication
You can enable 802.1x user identification (based on RADIUS user
authentication server) by checking ‘Enable 802.1x Authentication’ box
when you select ‘Disable’ or ‘WEP’ as encryption type, and the following
message will be displayed:
Here are descriptions of every setup item:
Use internal
MD5/PEAP
RADIUS Server
Uses built-in RADIUS Server (refer to next
Section) instead of external RADIUS server. If you
check this box, the value of internal RADIUS
server fields will be ignored.
Enable 802.1x
Authentication Enable or disable the use of 802.1x user
authentication.
RADIUS Server IP
address Please input the IP address of RADIUS
authentication server here.
RADIUS Server
Port Please input the port number of RADIUS
authentication server here. Default value is 1812.
RADIUS Server
Password Please input the password of RADIUS
authentication server here.
After you finish with setting, please click ‘Apply’, and the following
message will be displayed: