5 - setup and assembly – Cybex 425A Arc Trainer User Manual

Page 47

Advertising
background image

Setup

and Assembly

Page 5-1

5 - Setup and Assembly

Warnings/Cautions

Cybex Arc Trainer 425A Owner’s Manual

All warnings and cautions listed in this chapter are as follows:

WARNING: Use extreme caution when assembling the unit. Failure to do so could result in

injury.

WARNING: A minimum of two people are required to lift, move and assemble this unit.

Always use proper lifting methods when moving heavy items.

WARNING: Be sure that all electrical requirements are met as indicated in the specifications

at the front of the manual and at the beginning of this chapter prior to

proceeding.

WARNING: Wait until all moving parts come to a complete stop before dismounting.

CAUTION: A minimum of two people are required to assemble this unit.

Choosing and Preparing a Site

Before assembling the unit you must select a suitable site and have the proper electrical outlet power

available for optimum operation and safety. See the Electrical Power Requirements section (located on

the next page) for direction in locating your voltage requirements.

The area you select for the unit should be well lit and well ventilated. Locate the unit on a structurally

sound and level surface. Allow enough clearance for safe access and passage during use of the unit.

Allow a minimum of 5” (13 cm) behind the unit for the elevation to rise. If the unit is to be located above

the first floor, place it near or above major support beams. To protect the carpeting, place a 3/4” (1.9

cm) thick wood base under the unit. Be sure to use the rubber foot covers shown on page 5-9.

Humidity - The unit is designed to function normally in an environment with a relative humidity range of

30% to 75%.

NOTE: Do not install or use the unit in an area of high humidity, such as in the vicinity of a steam room,

sauna, indoor pool or outdoors. Exposure to extensive water vapor, chlorine and/or bromine

could adversely affect the electronics as well as other parts of the machine.

Temperature - The unit is designed to function normally in an environment with an ambient

temperature range of 50

o

F (10

o

C) to 104

o

F (40

o

C) degrees.

See Chapter 4 for information regarding storage of the unit.

Advertising