Cybex 425A Arc Trainer - Manual (Page 48)

Cybex Arc Trainer 425A Owner’s Manual
The power requirements for the unit are a grounded circuit rated for one of the following:
115 VAC 5%, 50/60 Hz and 15 amps; or 230 VAC 10%, 50/60 Hz. Contact your electrician to ensure
the power supply complies with local building codes. NOTE: Do not use a ground plug adapter to adapt
the 3-prong power cord plug to a non-grounded electrical outlet.
Setup
and Assembly
Page 5-2
Electrical Power Requirements
+_ +_
WARNING: Use extreme caution when assembling the unit. Failure to do so could result in
injury.
CAUTION: A minimum of two people are required to assemble this unit.
Tools Required
• Phillips head screwdriver
• 7/32” Allen wrench (2 supplied)
• 5/32” Allen wrench (supplied)
• 9/16” Open-end wrench
NOTE: The words “left” and “right” denote the user’s orientation.
1. Read and understand all instructions thoroughly before assembling the unit.
NOTE: Each step number in the assembly instructions tells you what you will be doing. The lettered
steps following each step number describe the procedure required. Do not continue with step 2
until you have carefully read all of the assembly instructions.
2. Verify you have received the correct package.
A. Read the sticker on the outside of the box and verify that the model number and voltage are
what you ordered.
3. Unpack and verify the contents of the boxes.
A. Lift up and remove the cardboard sleeve that surrounds the unit.
B. Verify that you have the color that you ordered by looking at the paint.
C. Verify that you have the correct voltage by reading the voltage sticker near the power inlet.
Assembling the Arc Trainer 425A