Cybex 625C Cycle Bike - Manual (Page 46)

Operation
Intended Use
The intended commercial use of this machine is to aid exercise and improve general physical fitness.
Terms Used
Any time the unit is controlling resistance and accumulating workout data. Active
Mode begins after pressing the Quick Start key, after completing the setup for a Active Mode
workout, or by default if the initial screen times out and enters Quick Start Manual
mode.
Display automatically cycles through workout data. Auto-Scan
A reduction of work load for a short duration allows user to gently reduce heart
rate. Cool Down occurs two minutes prior to completion of the workout-controlled
workout sessions. Cool Down
Occurs when unit is plugged in and not in use. Dormant Mode
Accommodating resistance, where unit provides a corresponding amount of
resistance on the user to keep them at a fixed pedal speed. Such exercise is used
to test and improve muscular strength and endurance, especially after injury. Isokinetic
Exercise
In this active mode the user sets a goal for Time. The user controls speed and
resistance. Manual Mode continues until the goal is reached. Manual Mode is only
available during Active Mode. Manual Mode
Occurs only if the Pause feature is enabled and user selects the STOP key from
Active Mode. Pause Mode
By default, the unit will end up in Quick Start Manual Mode if the user begins
pedalling and allows the 5 second count-down to end. Press the Quick Start key Quick Start
to enter into Quick Start Manual Mode, where the user controls the gear selection
and time is counting up.
User Control Symbols Used
Page 46 of 80
Cybex 625C/625R Cycle Part Number LT-23688-4 E