DFI EC700-BT Manual - Manual (Page 8)

www.dfi .com
8
Chapter 1 Introduction
Getting to Know the EC700-BT
Chapter 1
Front View
Antenna Holes
Used to connect to a Wi-Fi antenna.
USB Port
Used to connect USB 3.0 device.
COM Ports
Used to connect serial devices.
HDMI Port
Use to connect an HDMI device.
Status LED
This LED will blink when the system is in the standby mode.
HDD LED
Indicates the status of the hard drive.
Reset Button
Press to reset the system.
Power
Press to power-on or power-off the system.
Rear View
VGA Port
Used to connect a VGA device.
USB Port
Used to connect USB 2.0 devices.
COM Port
Used to connect serial devices.
LAN Ports
Used to connect the system to a local area network.
DC-in jack
Used to plug a power adapter.
USB 2.0
LAN 1/2
DC-in
VGA COM 3
COM 4 / 8-bit DIO COM 1
HDD LED
USB 3.0
HDMI
COM 2
Power
Reset
Status
LED
Antenna
Hole
Antenna
Hole
Antenna
Hole