DFI ML905-B11C/B16C - Manual (Page 10)

1
10
Introduction
Serial ATA
IDE
PCI Interface
Connectors
BIOS
Energy Efficient
Design
Power
Temperature
Humidity
PCB
• JMicron JMB362 PCI Express to SATA host controller
- x1 PCI Express to 2-port Serial ATA
• Supports 1-lane 2.5Gbps PCI Express bus
• Supports 2-port 3.0Gbps SATA II interface
• Bus Master IDE (PATA) controller
• Supports up to two IDE devices
• Ultra ATA 100/66/33
• Fully compliant with PCI Express to PCI/PCI-X bridge speci-
fication, revision 1.0
• Full x1 PCI Express Throughput
• PCI Express advanced error reporting capability including
ECRC support
• COM Express connectors
- Two 220-pin COM Express standard connectors
- Module connector pin: Tyco 3-1827231-6
• Award BIOS
• 8Mbit flash memory
• Supports ACPI specification 2.0/1.0
• Enhanced Intel
® SpeedStep Technology
• AC power failure recovery
- Depending on the type of power supply used, when us-
ing the “AC power failure recovery” feature to power the
system back on after an AC power failure occurs, the sys-
tem may not power back on if the power lost is resumed
within 4 seconds.
• Input: 12V, 5VSB, VCC_RTC
• 0
o C to 60 o C
• Operating: 10% to 90%
• Dimensions
- Micro COM Express form factor
- 9.5cm (3.74”) x 9.5cm (3.74”)
• Compliance
- PICMG COM Express R1.0 basic form factor, Type 2