DFI HM960-HM86 - Manual (Page 15)

www.dfi .com Chapter 3 Hardware Installation
15
Chapter 3
COM Express Connectors
The COM Express connectors are used to interface the HM960-QM87/HM86 COM Express
board to a carrier board. Connect the COM Express connectors (located on the solder side of
the board) to the COM Express connectors on the carrier board.
Refer to the “Installing HM960-QM87/HM86 onto a Carrier Board” section for more information.
COM Express Connectors
Refer to the following pages for the pin functions of these connectors.