DFI HM960-HM86 - Manual (Page 28)

www.dfi .com Chapter 3 Hardware Installation
28
Chapter 3
Installing HM960-QM87/HM86 onto a Carrier Board
1. Use the provided screw to install the heatsink onto the module. First align the mounting
hole of the heatsink with the mounting hole of the module and then from the bottom
side of the module, secure them with the provided screw. The module and heatsink as
sembly should look like the one shown below.
Mounting hol e
Mounting hole
2. Now install the module and heatsink assembly onto the carrier board. The photo below
shows the locations of the mounting holes on carrier board.
3. Insert the provided mounting screws into the mounting holes - from the bottom through
the top of the carrier board.
Mounting screws
• To download COM331-B datasheet and manual
Important:
The carrier board (COM331-B) used in this section is for reference purpose only and
may not resemble your carrier board. These illustrations are mainly to guide you on
how to install HM960-QM87/HM86 onto the carrier board of your choice.
Mounting hole
bottom side of heat sink
Mounting
screw
Top view Bottom view