DFI HM960-HM86 - Manual (Page 33)

www.dfi .com Chapter 3 Hardware Installation
33
Chapter 3
Side View of the Module, Debug Card and Carrier Board
7. Use the long mounting screws to secure them on the top of the COMe-LINK1 debug card
and the carrier board. The photo below shows the locations of long mounting screws.
6. Grasp HM960-QM87/HM86 with the heat sink by its edges and position them down firmly
on the top of the COMe-LINK1 debug card.
Long screws
COMe-LINK1
Carrier Board
COM Express Module
COMe-DEBUG
Cable
COMe-DEBUG
Cable