DFI HM960-HM86 - Manual (Page 38)

www.dfi .com Chapter 4 BIOS Setup
38
Chapter 4
Turbo Mode
If you want the system to run at a faster speed, set this field to Enabled. However,
compatibility problems may occur with some DRAMs if the system is running in Turbo
mode. If you encounter this problem, set this field to Disabled.
Intel TXT (LT) Support
Enable or disable the support of Intel Trusted Execution technology.
SATA Configuration
This section is used to configure the settings of SATA device.
Enable or disable SATA
Device.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
SATA Controller(s)
SATA Mode Selection
Serial ATA Port 0
Software Preserve
Serial ATA Port 1
Software Preserve
Serial ATA Port 2
Software Preserve
Serial ATA Port 4
Software Preserve
Serial ATA Port 5
Software Preserve
Advanced
SATA Controller(s)
This field is used to enable or disable the Serial ATA channels.
SATA Mode Selection
Determine how the Serial ATA controller(s) operates.
IDE Mode
This option configures the Serial ATA drives as Parallel ATA storage devices.
AHCI Mode
This option allows the Serial ATA devices to use AHCI (Advanced Host Controller
Interface).
RAID Mode
This option allows the Serial ATA devices to use RAID 0/1/5/10/Recovery (Redundant
Array of Independent Disks)
[Enabled]
[IDE]
Empty
Unknown
Empty
Unknown
GLS85LS1004A C (4.0GB)
Supported
Empty
Unknown
Empty
Unknown
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit