HP Velotechnik trikes - Manual (Page 14)

Safety instructions (bicycle)
10
Position for identification mark on the Scorpion fs 26
frames
Scorpion, Scorpion fs and Scorpion fx
On Scorpion, Scorpion fs and Scorpion fs use
the lower stay on the right side of the gusset
sheet for identification numbers, as like the
position of the frame number on the other
side.
Position of frame number on Scorpion fs and Scorpion fx
Gekko, Gekko fx, Gekko fx 26
On Gekko, Gekko fx and Gekko fx 26 frames,
the identification number can be engraved be-
sides the frame number on the cross tubes
gusset sheet. (Some older models have the
frame number engraved on the rear end be-
tween the chain stays facing to the tire.)
Position of frame number on Gekko models
Added parts and accessories
Caution! Mounting additional
parts or accessories is at your own risk. It
is important that you carefully read the in-
stallation guide of the manufacturer. Addi-
tions to the handlebar like fairings,
handlebar fittings, bottle holders, etc. may
impair your safety due to additional loading
or clips with sharp edges.
Additional accessories may impair the func-
tion of your Scorpion fs 26. We advise you to
generally ask your dealer before you mount
any special parts or accessories to your tricy-
cle.
Take care that the handlebar and the suspen-
sion always stay moveable. You must not add
any parts to the handlebar or the seat that
might endanger the rider through sharp edged
or pointed shapes while steering, getting on
and off the tricycle or bumping against some-
thing.
Before you purchase a bell or a lighting sys-
tem make sure that these accessories con-
form to your national laws and regulations.
Additional accessories may invalidate the op-
erating licence or impair the function of your
S-Pedelec. This may also be valid for accesso-