Adjusting your new tricycle – HP Velotechnik trikes User Manual

Page 26

Advertising
background image

Adjusting your new tricycle

22

flow Cushion features additional rigid mesh
padding.

Raincover

To keep the seat dry when your tricycle is
parked you can additionally purchase a rain-
cover. It can be carried in the optional Micro-
bag or in the bag the ErgoMesh seat is
equipped standard with.

Caution! Don’t sit down on the

raincover. It may get damaged.

The ErgoMesh®-seat for Scorpion,
Scorpion fx, Scorpion fs, Scorpion fs 26
/S-Pedelec /Enduro, Scorpion plus 20 /26

The ErgoMesh® seat is ergonomically shaped
and supports the natural S-curve of your spi-
ne. Forces from pedalling are supported in the
area of your lower back just above your hips
(lumbar support).

Eight tension belts on the back side of the
seat allow the adjustment oft the seat net to
your needs.

Does the seat feel to soft or gives you the
feeling of sitting on the seat frame, increase

the tension of the belts on the back side of
the seat.

Is it hard or uncomfortable, or do you feel li-
ke slipping off when going through curves, re-
lease the belts in the relating area.

It may be necessary to put a high force on the
belts to apply sufficient tension to the belts. If
it can not be done by hand, make use of a flat
nose pliers and pull the lose end of the belts
firmly. To easily loosen the belt, pull up the
round end of the strap retainer.

The angle of all ErgoMesh

®

-seats can be ad-

justed. Loosen the upper and the lower quick-

release lever – the middle lever should remain
closed.

Move the seat into the desired angle. Then
close the upper and lower quick-release lever,
regarding the sheets are completely covered
by the hole diameter of the clamping surface.

To adapt the tricycle perfectly to your needs,
we offer the following versions of the Ergo-
Mesh

®

-Seat besides the standard version.

ErgoMesh®-seat standard (l.) and ErgoMesh® HS (r.)

The ErgoMesh

®

XL-versions

All ErgoMesh

®

-seats are available as XL ver-

sion. These are 3 cm longer and 5 cm wider
than the standard versions. They are meant to
give strongly build persons a comfortable seat
option.

The ErgoMesh

®

plus versions

The ErgoMesh

®

-plus seats have been designed

to simplify getting on and off the tricycle.
With a plus of 11 cm seat height compared to

the ErgoMesh

®

-standard seats, they give you a

better overview in traffic.

Caution! When using the Ergo-

Mesh

®

plus seats, be careful when riding

through bends. Due to the increased
height the tricycle may tend to tip over
easily.

Advertising