HP Velotechnik trikes - Manual (Page 78)

Front suspension elements
74
Loosen the hex head bolt on the clamp before adjusting
the-pre load
Danger! The mounted spring is
under tension. Do not remove the preload
adjuster when adjusting the spring preload.
Make sure the adjusting disc's thread is
fully screwed into the stanchion tube. Oth-
erwise it may become loose and hurt you.
The damping rate can be altered by exchang-
ing the elastomer bands inside the suspension
struts, see “Removing and disassembling the
suspension struts” on page 77.