Johnson Amplification J-STATION - Manual (Page 25)

Effects
The Effects module in the J-Station is a multi-function module, allowing you to select effects such as; Chorus,
Flanger, Phaser,Tremolo, Rotary Speaker, AutoWah (Envelope Filter), Pitch Shift and Detune effects. Only one
of these effects can be used at a time.The Effect Type button is used to select the currently active Effect in
Top Level editing.The selected Effect type will be indicated by the Effect name lighting in the Effect Matrix.
Successive presses of the Effect Type button will advance through all available Effect Types. After selecting
the type of effect in this module, you can then adjust the effects individual parameters.
On/Bypass - This Parameter turns the Effects module on and off.This Parameter may be accessed by press-
ing the Effect Type button until no name in the Effect matrix is lit. It is accessed in the Deep
Level edit mode by selecting Parameter number 19.A value of 00 relates to bypass and 01 is
on.
Type - This Parameter allows you to choose the type of Effect. In Top Level editing it is accessed with the
Effect Type button and in Deep Level editing by selecting Parameter number 20.The value for
selecting each of these effects is listed with the effect name. A detailed description of each effect type
and the associated Parameters follows is listed below the description of the Level Parameter.
Mix - This Parameter adjusts the overall mix of the modulation and pitch shift effects. It is adjusted in Top
Level editing by rotating the Effects/Speed knob. It is accessed in Deep Level editing by selecting
Parameter number 21.The Level values range from 00 to 99.
Chorus (value 00)
A Chorus adds a short delay to your signal and modulates the delay time which takes the delayed
signal slightly in and out of tune.The delayed signal is then mixed back with the original signal to
create a thicker sound as if two guitars were playing the same part. Chorus Parameters are as fol-
lows:
Speed - Controls the rate at which the Chorus modulates.This Parameter is accessed in Top
Level editing by pressing the Shift button and rotating the Effects/Speed knob. It is
accessed in Deep Level editing by selecting Parameter number 22.Values range from 00
to 99.
Depth - Sets the amount of intensity in the Chorus. Depth is only available in the Deep Level edit
mode and is accessed by selecting Parameter number 23. Values range from 00 to 99.
Regen - This Parameter adjusts the amount of chorus signal fed back to the input of the Module.
Regeneration is only available in the Deep Level edit mode and is accessed by selecting
Parameter number 24. Values range from 00 to 40.
Flanger (value 01)
A Flanger uses the same principle as a Chorus does with a modulating delay. The difference being
that a Flanger uses a shorter delay time and adds regeneration (or repeats) to the modulating
delay. This results in an exaggerated up and down sweeping motion to the effect. Flange
Parameters are as follows:
Speed - Controls the rate at which the Flange modulates.This Parameter is accessed in Top Level
editing by pressing the Shift button and rotating the Effects/Speed knob. It is accessed
in Deep Level editing by selecting Parameter number 22.Values range from 00 to 99.