Dish Network DuoDVR 625 - Manual (Page 113)

Chapter 3
Page 108
Using the System
If you are repeating this
procedure to program a
combination device, be sure to
press the correct mode button
(for example, if you have a
TV/VCR combination and
you have already programmed
the remote to control the TV,
press and hold the VCR mode
button as described above).
4. For AUX mode only:
• Press 0 for a second TV.
• Press 1 for a second VCR
or DVD player.
• Press 2 for a tuner or
amplifier.
This step is for programming which
kind of device that should be
programmed in AUX mode. If
you’re not programming in AUX
mode, skip to step 5.
5. Enter one of the three-digit
device codes from the table
using the number buttons.
The three-digit device code should
be for the brand name of your device
that you found in step 2.
6. If you want to program
limited mode, press 1. If not,
skip to step 7.
See Limited Mode for more
information.
7. Press the POUND (#) button. If you entered the code correctly, the
mode button flashes three times.
8. Press the blank POWER
button to turn off the device. If
the device does not turn off,
go to step 10.
If the code works, the device should
turn off.
9. Turn the device back on and
try some other buttons to
make sure they work. If the
code works for other buttons,
stop here.
Sometimes the blank POWER
button works when other buttons
don’t.
10. If the code doesn’t work, redo
steps 3 through 9 with another
device code from the tables.
Try every code listed for you brand
until one works for your device.
11. For combination devices:
Repeat this procedure from
step 3.
12. If you can’t find a code that
works try Scan for Device
Codes that follows.
Instructions Additional Information
Tip: Limited mode is
not used with audio
amplifiers.