Dish Network DuoDVR 625 - Manual (Page 34)

Page 29
Connecting the Receiver to a Nearby TV
Connecting the Receiver to a Nearby TV
This section describes how to connect receiver TV 1 output ports to a nearby TV.
The easiest way to connect the receiver to the TV is using coaxial cable
connections, but you may also use RCA or S-Video outputs.
Coaxial Cable Connections
1. Connect a coaxial cable from the CH 3-4 output on the receiver to the
nearby TV’s tuner port.
2. Place the white CH 3-4 sticker on the cable near where the cable connects to
the receiver (see the picture in the margin).
3. Plug in the power cord for the receiver.
4. Turn on the receiver with the front panel power button and make sure the
green TV1 indicator is lit.
5. Turn on the nearby TV.
6. Tune the TV to channel 3.
7. You should see the Point Dish screen.
8. If you do not see the Point Dish screen, tune the TV to channel 4.
Note : If you want to change the channel that the CH 3-4 port provides to
your TV, see Changing the TV1 and TV2 Output Channels on page 37.
9. If desired to remind you of which TV channel (3 or 4) to tune to watch
satellite programming, place one of the channel stickers (3 or 4) near or on
your TV. The stickers are located in the inside front cover of this guide.
Tip: Using cable
labels makes it easy
to tell which cables
connect to the
receiver ports.
Inside the front
cover of this guide
are stickers that are
color coded the
same way as the
coaxial
connections.