Dish Network DuoDVR 625 - Manual (Page 57)

Chapter 3
Page 52
Using the System
Switching Between Dual and Single Mode
Put the satellite receiver in Dual or Single Mode by pressing the front panel
Mode button. Keep the following items in mind when switching the satellite
receiver between Dual and Single Mode :
Using the Remote Controls
The following section describes how to use the remote controls with your
satellite receiver. The remote control must be in SAT mode for the buttons to
control the satellite receiver. You can also use the remote to control your VCR
and other devices. See Control Other Devices with the Remote on page 106.
SAT Mode Button
Press the SAT mode button to set the remote to SAT mode, to control the
receiver. The SAT mode button’s back light turns ON briefly to show that the
remote is set to SAT mode.
Power Buttons
Press the blank POWER button to turn TV1 or TV2 (depending on which
remote is being used) ON or OFF. Press the TV POWER button to turn the TV
on or off.
Note : You must program the remote to control your TV for the TV POWER
button to work as described. See page 106 for instructions.
Dual Mode Single Mode
Indications
DUAL MODE front panel
indicator lights.
SINGLE MODE front
panel indicator lights.
Recording
The RECORDING front
panel indicator lights to
show which TV is currently
recording.
The TV1 RECORDING
front panel indicator lights
when you are recording
from one or both tuners.
Favorites
Lists
Favorites Lists set up for
both outputs ( TV1 and TV2 )
are available.
Favorites Lists set up for
only TV1 are available. The
lists for TV2 are not lost,
they are simply unavailable
in Single Mode .
Locks
Locks set up for both
outputs ( TV1 and TV2 ) are
available.
Locks set up for only TV1
are available. The locks for
TV2 are not lost, they are
simply unavailable in
Single Mode .
Tip: Remote
Control 1 is used to
control TV1 menus
on the nearby TV.
Remote Control 2
is used to control
TV2 menus on the
remote TV(s).