Dish Network DuoDVR 625 - Manual (Page 132)

Page 127
Installing a Multiple Dish DISH Pro System
12. Connect two RG-6 cables between both ports on your DISH Pro Twin
LNBF and your switch(es) using the switch instructions and the DISH Pro
Wiring Diagrams that start on page 128.
13. Select Check Switch from the Point Dish menu. When the Check
Switch menu opens, select Retest. When the procedure completes, you
will see the Installation Summary screen again. This time you should
see confirmation for all satellites your dishes are pointed at, and “Satellite
reception verified.” You should also see that the switch(es) in your system
has been correctly identified.
Refer to the DISH Pro wiring diagrams for examples of installation
summary screens.
14. Press CANCEL to exit this menu, and then Done to exit the Point
Dish screen. If you have any other receivers in your system, make sure you
run Check Switch on each of them, and allow each to take the software
upgrade, as needed.