Dish Network DuoDVR 625 - Manual (Page 36)

Page 31
Connecting the Receiver to the TV(s) in Another Room(s)
Connecting the Receiver to the TV(s) in Another
Room(s)
This section describes how to connect the receiver CH 21–69 O UT
connection to
the cable-ready remote TV located in another room away from the receiver. This
installation uses your in-home cable system. If your house does not have built-in
cabling, it will be necessary to run cables from the receiver to each remote TV.
Due to the difficulty of this installation, you should consider having this
professionally installed. Call DISH Network at 1-800-333-DISH (3474).
Note : When connecting to the home distribution ( CH 21–69 O UT
) coaxial port,
you must meet the FCC requirements in the Appendix. To meet these
requirements, an in-line coaxial attenuator has been included with your receiver
and may need to be installed using the following guidance:
• If connecting to your in-home cabling system to distribute the signal to a
TV(s) in other rooms, in most cases you will not have to install the
attenuator on the CH 21–69 port for typical in-home cabling systems.
• If connecting directly to a TV tuner port, you must install the attenuator in
the cable between the CH 21–69 O UT
port and the TV tuner.