Dish Network DuoDVR 625 - Manual (Page 33)

Chapter 2
Page 28
Receiver Description and Installation
Batteries
The remote controls come with AAA batteries, which need to be installed when
you first receive your system. When you replace old batteries, you should
replace all of the batteries. Use batteries of the same kind, for example alkaline
or carbon zinc, and don’t mix batteries of different kinds. Alkaline batteries last
longer than carbon zinc.
Installing or Changing the Batteries
1. Press down on the battery cover’s top latch and slide the
cover off.
2. If you are changing the batteries, take out all of the old
batteries.
3. Put the new batteries in. Make sure you match the plus
(“+”) ends with the plus markings on the battery case.
4. Slide the cover back into place.
Low Battery Warning
When you see a low battery warning message below the Program Banner , the
batteries in your remote control are weak and need to be replaced.
Attach a UHF Antenna
You need to attach the UHF remote antenna to the
receiver’s back panel R EMOTE A NTENNA
input so you can
use UHF Pro Remote Control 2.
Note : Be sure to set the antenna straight up so you can use the remote control
from as far away as possible. Don’t let the antenna touch anything.