MBM Corporation 45 - Manual (Page 14)

T10113 Mar 2000
3.2 Adjusting the envelope feeder
NOTE: The friction between the envelopes and the
envelope feed belts is also essential for proper
envelope feeding. Therefore the rear envelope
guide (B) must be adjusted properly.
Envelopes
Place one envelope on the envelope feeder so the right
edge stops against the envelope separator pads (A).
Loosen the knob on the rear envelope guide (B) and
slide it so that it is in line with the left edge of the enve-
lope.
Bags
Place one bag on the envelope feeder so the right edge
stops against the envelope separator pads (A). Loosen
the knob on the rear envelope guide (B) and slide it so
that the left edge of the bag reaches the top of the
slope.
NOTE: It is important for the envelope feeding that the
gap between the envelope separator pads and the
envelope feed belts is correct and equal!
A B
envelope
feed belt envelope
separator pad
Default setting:
Press the envelope feed belt downwards at the arrow
and thighten the envelope separation adjustment knob
until there is no gap between the separator pad and the
feed belt. Then loosen the adjustment knob one and a
half turn. To facilitate adjustment, use a flash light and/
or a 0.05 mm feeler gauge.
If double feed occurs: Thighten the adjustment knobs.
If miss feed occurs: Loosen the adjustment knobs.
Mailer/inserter Model 45 Operator Manual 3-3