MBM Corporation 45 - Manual (Page 15)

T10113 Mar 2000
Mailer/inserter Model 45 Operator Manual 3-4
3.3 Loading envelopes
The water bottle is mounted upside down and fills water
into the wetting system through holes in the cap.
Press down the water bottle slightly. Remove the bottle
by turning it over and lifting it out. Fill the bottle with
fresh water and tighten the cap. Put the bottle back in
the same position.
Slide the envelope feeder side guides away from each
other. Load the rest of the envelopes, not higher than up
to the red mark, with the flap up and to the left. Slide
the envelope feeder side guides towards each other
against the envelopes without squeezing.
The right side of the envelope stack should be straight
and make sure the envelope low symbol disappears
from the display.
NOTE: • Before loading the envelopes, fan them
properly to make sure they are not glued
together.
• Also bend the envelopes perpendicular to
the feed direction, to make sure the
envelopes have proper contact with the
envelope feed belts.
• When running, make sure one or two
envelopes falls down to the feed belts and
the rest of the stack should lay onto the
rear envelope guide. Adjust the rear guide
if necessary.
3.4 Filling water
envelope low symbol