MBM Corporation 45 - Manual (Page 22)

T10113 Mar 2000
5.1 Cleaning the water tray, continues
Mailer/inserter Model 45 Operator Manual 5-2
correct position
water tray
guide plate
incorrectly positioned
guide plate
5.2 Cleaning the envelope sealing flap
The envelope sealing flap (stainless steel) and a guide
plate (stainless steel) under it, aswell as the painted
plate under the two leftmost rollers will eventually need
cleaning due to glue build-up.
• Clean the envelope sealing flap and the guide plate
by lifting app. 10mm at the green dot. To facilitate
cleaning, the rightmost roller can be removed. Press
down the envelope sealing flap and remove the roller
by pushing it to the rear (1) and lifting the front end (2).
• Clean the painted plate under the rollers. If neces-
sary remove the painted plate by lifting the rightmost
edge as shown in figure (and same place opposite
side). Close the envelope feeding table and pull the
plate out towards the receiving tray.
envelope
sealing flap lift painted
plate here
1
2