ONICON D-100 Flow - Manual (Page 7)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • [email protected]
D-100 Flow Display Manual 10/14 - 0634-14 / 18340 Page 7
1.4 ADDITIONAL REQUIRED HARDWARE
Flow Meter
ONICON offers a wide variety of flow meters to satisfy most liquid, gas and steam
metering applications. Please refer to ONICON’s flow meter literature, or consult
ONICON or your local representative for help in selecting the flow meter that will best
fit your requirements.
1.5 WORKING ENVIRONMENT
The D-100 was designed for installation and use in typical industrial environments that are
free of corrosive liquids and fumes, direct liquid exposure, heavy condensation, temperature
extremes, and vibrations. Do not expose the display to direct sunlight.
The operating ambient air temperature range is - 20° F to 140° F. Electrical power should be
relatively clean, free of high frequency noise, large voltage transients, and protected from power
surges and brown-outs.
1.6 WARRANTY & SERIAL NUMBER
Warranty
ONICON’s 2-year “No-fault” warranty reduces start-up costs by extending coverage for
incidental damage during installation. Certain exclusions apply. Please refer to ONICON’s
Conditions of Sale for details.
Serial Number
The serial number of your D-100 is located outside and inside the enclosure. Also located
inside the enclosure is a label with the serial number of the associated ONICON flow
meter or sensor your D-100 was intended to be used with. The serial numbers are unique
identifiers that you should have available when contacting ONICON for assistance
regarding the installation or use of this product.
SECTION: 2.0 UNPACKING
The D-100 is shipped in one package unless optional hardware or equipment is ordered. Notify the
freight carrier and ONICON if any items are damaged in transit.
2.1 CHECKING THAT YOU HAVE RECEIVED EVERYTHING
• Standard Documentation
Enclosed with each D-100 is a comprehensive documentation package that includes the
following items:
The D-100 Installation and Operation Guide
The D-100 Configuration Data Sheet
i
IMPORTANT NOTE
The ONICON D-100 is delivered fully programmed and ready to use with a specific flow meter.
The serial number of the flow meter and any other sensor used with this D-100 will be found on
a label located inside the enclosure. Do not attempt to use the D-100 with any other flow meter
or sensor. Doing so will result in significant errors in the flow reading.