OnLine Power Phase Stabilizer - Manual (Page 65)

OnLine Power
6002-032 REV H 4-2
4-2 REMOTE EMERGENCY POWER OFF STATION, Constant Power 18
The Remote Emergency Power Off Station (REPO) is a wall-mounted unit that enables operating personnel to
remotely shut down the Power Conditioner or Voltage Regulator in an emergency. The REPO station consists
of a painted sheet metal enclosure with a guarded, momentary, normally open, red tactile switch. See
Illustration 4-1 for REPO-box size and mounting hole location.
The REPO station is designed to be vertically mounted and can be located anywhere an emergency shut-off is
required. The REPO station is provided with a 50-foot, two-conductor cable (15 m). Other length cables are
available in five-foot increments.
3(7.6)
4(10.2)
7
(1
7
.8
)
2(5.1)
REPO BOX
ILLUSTRATION 4-1
4-2-1 Installation for REPO
The REPO cable will be 50 to 100 feet (15 - 30 m) long depending on length ordered. The cable is supplied
with a two-pin connector on one end and bare wires on the other end. The bare wires connect to a terminal
block in the CP 18.
Procedure
1. Select the location for the REPO box.
2. Mount REPO box on wall or other structure using fasteners that are appropriate for the surface on which the
REPO box is to be mounted.
3. Remove REPO box cover.