OpenEye OE-C7163 User Manual
Page 22
31186AE
23
5.
Thread the power and Ethernet cables through either the side conduit entry or
back conduit entry. Then fasten the Dome Camera
’s housing to the Electrical
Box with the two screws.
6.
Connect the power and Ethernet cables to their connectors on the Dome Camera
unit.
7.
Attach the snap-on module to the camera housing, and screw the module screw
tightly with the Security Torx to secure the camera module.
8.
Use the OpenEye IP Finder software to locate the camera on the network and
complete configuration of the camera.
9.
After connecting to the camera, adjust the camera's zoom level and focal length
using the zoom and focus ring screws.
10.
Replace the inner dome cover.
11.
Replace the dome cover, aligning the arrow mark on the dome cover with the
one on the housing.
12.
Screw the two Torx screws on the side of the dome cover tightly to fasten the
dome cover.