REMKO RVS 60 H - Manual (Page 4)

Safety notes
Environmental
protection
and recycling
Disposal of packaging
All products are packed for trans-
port in environmentally friendly
materials. Make a valuable con-
tribution to reducing waste and
preserving raw materials. Only
dispose of packaging at approved
collection points.
Disposal of equipment
and components
Only recyclable materials are used
in the manufacture of the system
and components.
Help protect the environment by
ensuring that the system or com-
ponents (for example batteries) are
not disposed in household waste,
but only in accordance with local
regulations and in an environmen-
tally safe manner, e.g. using certi-
fied firms and recycling specialists
or at collection points.
Carefully read the operating in-
structions before commissioning the
system. It provides useful tips and
information as well as hazard
warnings to prevent injury or mate-
rial damage .
Failure to follow the directions in
this manual can result in injury,
damage to the environment and
the system itself and will null in
void any claims for liability.
■
Keep this manual and the refrig-
erant data sheet by the system.
■
The system or components
are not to be exposed to any
mechanical stresses, extreme
levels of humidity or extreme
sunlight.
■
The unit should be set up and
installed only by qualified per-
sonnel.
■
The installation, connection and
operation of the system and its
components must be carried out
in accordance with the operat-
ing instructions as stipulated in
this manual and comply with all
applicable local regulations.
■
Mobile systems must be set up
securely on suitable surfaces and
in an upright position. Stationary
systems must be permanently
installed for operation.
■
Modification of the system or
its components supplied by
REMKO is not permitted and
can cause malfunctions.
■
The system and components
may not be operated in areas
where there is an increased risk
of damage. Observe the mini-
mum clearances.
■
The electrical supply should be
adapted to fulfil the require-
ments of the system.
■
The operational safety of system
and components is only assured
if they are fully assembled and
used as intended. Safety devices
may not be modified or discon-
nected.
■
Do not operate the system or
components with obvious de-
fects or signs of damage.
■
All housing parts and openings
in the system, e.g. air inlets and
outlets, must be free of foreign
objects, fluids, or gases.
■
The system and components
must not be installed in hazard-
ous areas or areas where the air
is contaminated with abrasive/
corrosive materials or dust.
■
Touching some parts of the sys-
tem can result in burns or other
injury. Wearing appropriate
protective clothing is necessary
to avoid risks.
■
Only authorised personnel and
personnel trained in the use of
the system and its components
are permitted access to and
allowed to operate the system
and its components.
■
Installation, repair and mainte-
nance work should only be car-
ried out by authorised person-
nel. Inspection and cleaning can
be performed by the operator
providing the system is not un-
der current/voltage.
■
To avoid any risks to persons,
appropriate precautions are to
be taken when installing, repair-
ing, maintaining, cleaning or
working on the system.
■
The system or components
are not to be exposed to any
mechanical stresses, extreme
levels of humidity or direct
sunlight.
REMKO RVS...H (INOX)
4