Seaward Test n Tag Printer - Manual (Page 16)

15
5. Printing Labels ( Supernova / Europa )
Note
This section should be read with reference to the tester’s Instruction
Manual
Labels can be printed either at the end of test or at any other time
from test results stored in the memory.
Note
When printing labels from a newly installed Supply Cartridge the first
label to be printed will not have a logo – even if a logo has been
added to the label (see section “Adding a Logo to the Label” ).
Note
There is an option in the System Configuration, Aplnce & Cmnts,
which allows the Appliance ID length to be limited to 10 digits, it is
recommended that this option be set. Appliance ID’s which are
greater than 12 digits in length will not produce barcodes on the Test
‘n’ Tag printout.