Tech Source GFX 400 Series - Manual (Page 26)

GFX 400 Series Installation and Reference Manual
3-14
Enter Selection, q to quit: a
/pci@1f,0/SUNW,m64B@13 has been selected
Type ^Y ( Control-Y ) to insert it in the
command line.
e.g. ok nvalias mydev ^Y
3.
Set the selected device as the console device by typing:
ok setenv output-device <Control-Y>
4.
Power off the system.
5.
Connect your monitor cable to the onboard VGA connector
on your system back panel.
6.
Power on the system.
3.6.2 GFX 400 Card with a Secondary Framebuffer
The GFX 400 card can be made the console device when other
secondary framebuffers are present in the system.
To configure the GFX 400 card as the console when UPA based
device or other framebuffers are in the system, the output-
device
variable in NVRAM must be changed to the actual path
of the desired GFX 400 card. This path can best be determined
by searching for the string "TSI" in the / tree at the "ok" prompt.
For example, to find the PCI devices, at the "ok" prompt, type
the following:
ok show-devs
You should see at least one entry containing the string "TSI", ie.
"TSI,mko@#", where ‘#’ will be a digit representing the PCI slot
containing the GFX 400 card.