Tech Source GFX 400 Series - Manual (Page 43)

Appendix A – Changing the Console Resolution
A-5
35
1920X1080X60
36 1920X1080X72*
37 1920X1080X80
38 1920X1200@60
39 1920X1200@70
40 1920X1200@76
NOTE: Please refer to Appendix C for a description of nvedit
commands.
ok nvedit
0: 8 value video-mode
1: <ctrl-c>
ok nvstore
ok setenv use-nvramrc? true
ok reset-all
NOTE: The last three commands enable the NVRAM. Without
these lines, the changes you make with nvedit will be ignored.
A.4 Video-Timing Method
If all of the previously described methods fail for your
configuration, it is possible to specify the exact timing numbers
for a particular resolution. The last method for setting the
console resolution also uses nvedit. This method is more
involved and requires knowledge of all timing parameters for the
desired resolution, and is only meant for monitors whose
resolutions are not available in the video-mode method.
Please refer to Appendix C for detailed instructions on using
nvedit
.
NOTE: The video-timing method should be used only if the
previous methods have been unsuccessful.
NOTE: The resolution followed by a * uses composite sync.