Visara CNA-8000 Installation - Manual (Page 112)

Chapter 10. TN3270 Client Configuration
10-8 707158-003
Any pools that already exist will be contained in the Pool Name dropdown control. To
add pools, press the [New] button. Enter the name for the new pool and enter the sessions
that you want to include in the pool and press the [Update] button to save the
information. The name that you select for the Pool Name must be 16 characters or less.
Resources are added to the pool by defining the Host Circuit and LU range within that
circuit then pressing the [Include] button.
Field Definitions:
Pool Name: This is a dropdown control that lists all of the pools that have been defined.
Selecting one of the pools in the list will cause a list of the host session resources that are
part of the pool to display in the list control below the pool name.
Host Circuit: This is a dropdown control with a list of all of the host circuits that have
been defined. Selecting a host circuit from the list will allow you to input a range of LUs
that you wish to include in the pool or to exclude from the pool.
LU Range: This allows you to input the low end and high end of a range of LUs to be
used with the Host Circuit dropdown.
Button Definitions:
Delete Selected Range: Pressing this button will delete the highlighted range from the
selected pool.
Include: Selecting this button will copy the indicated LU Range into the pool identified
by the Pool Name dropdown control.
Exclude: Pressing this button takes the information configured in the LU Range and
eliminates the range from the pool.
Return: Selecting this returns you to the TN3270 Configuration menu.
New: Pressing the [New] button converts the Pool Name field to a data entry field
allowing you to define a new pool name.
Delete: This button allows you to delete the selected pool as indicated by the Pool Name
control.
Update: Pressing this button saves the changes that you have made while on this panel.
When defining a new pool, you must press the [Update] button to save the new pool. A
message that the pool was successfully updated should appear to confirm that the pool
has been created.