Visara CNA-8000 Installation - Manual (Page 124)

Chapter 11. RPQs
11-2 707158-003
A panel similar to that below should appear.
Below is a brief description of the RPQs listed on this panel. For further information on
any of the RPQs or to request a feature not offered, contact your local Visara
representative.
UNBIND Before NOTIFY Power Off Sequence: Normally when a client disconnects
gracefully from the CNA-8000, a NOTIFY is sent to the application followed by an
UNBIND request to VTAM. Enabling this RPQ reverses the order of these two events.
Disconnect TN3270 Clients that Violate SNA Protocol: Normal operations when SNA
protocol is violated include sending an SNA sense code to VTAM to report the error, but
the client remains connected to the CNA-8000 unless some other event such as an
UNBIND occurs and the option to Disconnect on UNBIND is configured. When this
option is enabled, the TN3270 client will be forcibly disconnected from the CNA-8000
and the power off sequence will be followed to report the client’s departure.
Pass WRITE STRUCTURED FIELDS to LU3 TN3287 Clients: Not all TN3287
clients support WRITE STRUCTURED FIELDS so they may not automatically be sent
to the client unless this RPQ is enabled.
Use Terminate-Self Instead of Inbound UNBIND: Normally when a client wishes to
end a session and UNBIND will be generated (requested log off or session ending due to
a problem). With this option enabled, an SNA Terminate-Self will be sent in place of an
inbound UNBIND.
Maximize TN3287 Response Timer: When enabled, the response timer used to time
out a TN3287 client when it has been requested to perform a print will be increased to a
value much larger than normal to allow the client more time to perform its function and
respond.