H3C Technologies H3C S12500X-AF Series Switches - Manual (Page 12)

8
Figure 8 Attaching the right slide rail to the right front rack post
5. Keep the slide rail horizontal and adjust its length until the installation holes on the rear end of the
slide rail touch the cage nuts on the rear rack post. Then use screws to attach the slide rail to the
rear rack post.
Install a screw in each mounting hole of the slide rail to ensure its weight bearing capacity.
6. Repeat steps 4 and 5 to install the other slide rail. Make sure the two slide rails are at the same
height so that the switch can be placed on them evenly.
Figure 9 shows the installed slide rails.
Figure 9 Installed slide rails