H3C Technologies H3C S12500X-AF Series Switches - Manual (Page 35)

31
Figure 31 Installing a filler panel in a switching fabric module slot (S12516X-AF switch)
(1) Push the filler panel slowly into the slot (2) Simultaneously rotate the ejector levers inward
(3) Fasten the captive screws on the ejector levers
Removing a filler panel from a switching fabric module slot
1. As shown by callout 1 in Figure 32 , loosen the captive screws on the ejector levers.
2. As shown by callout 2 in Figure 32 , rotate outward the ejector levers. Then pull the filler panel
part way out of the slot.
3. As shown by callout 3 in Figure 32 , hold the filler panel by the top and bottom edges to pull the
filler panel out of the slot.
Keep the removed the filler panel secure for future use.