H3C Technologies H3C S10500 Series Switches User Manual
Page 46
# Set the member ID of Device B to 2, create IRF ports 1 and 2, and bind them to physical ports
Ten-GigabitEthernet 3/0/2 and Ten-GigabitEthernet 3/0/1 respectively.
<Sysname> system-view
[Sysname] irf member 2
Info: Member ID change will take effect after the switch reboots and operates in IRF mode.
[Sysname] irf-port 1
[Sysname-irf-port1] port group interface ten-gigabitethernet 3/0/2
[Sysname-irf-port1] quit
[Sysname] irf-port 2
[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/1
[Sysname-irf-port2] quit
# Save the current configuration to the startup configuration file.
[Sysname] quit
<Sysname> save
# Connect Device B to Device A as shown in
.
# Switch the operating mode of Device B to IRF.
<Sysname> system-view
[Sysname] chassis convert mode irf
The device will switch to IRF mode and reboot. You are recommended to save the current
running configuration and specify the configuration file for the next startup. Continue?
[Y/N]:y
Do you want to convert the content of the next startup configuration file
flash:/startup.cfg to make it available in IRF mode? [Y/N]:y
Please wait...
Saving the converted configuration file to the main board succeeded.
Slot 1:
Saving the converted configuration file succeeded.
Now rebooting, please wait...
Device B and Device A form an IRF fabric after Device B reboots.
3.
Configure Device C
# Set the member ID of Device C to 3, create IRF ports 1 and 2, and bind them to physical ports
Ten-GigabitEthernet 2/0/1 and Ten-GigabitEthernet 2/0/2 respectively.
<Sysname> system-view
[Sysname] irf member 3
Info: Member ID change will take effect after the switch reboots and operates in IRF mode.
[Sysname] irf-port 1
[Sysname-irf-port1] port group interface ten-gigabitethernet 2/0/1
[Sysname-irf-port1] quit
[Sysname] irf-port 2
[Sysname-irf-port2] port group interface ten-gigabitethernet 2/0/2
[Sysname-irf-port2] quit
# Save the current configuration to the startup configuration file.
[Sysname] quit
<Sysname> save
# Connect Device C to Device A as shown in
.
# Switch the operating mode of Device C to IRF.
40