H3C Technologies H3C MSR 50 - Manual (Page 81)

72
Configuration procedure
You can configure WLAN service-based client rate limiting, so that the fat AP can limit client rates for a
WLAN service.
To configure WLAN service-based client rate limiting:
Step Command Remarks
227. Enter system view. system-view N/A
228. Enter service template view.
wlan service-template
service-template-number
{ clear | crypto }
N/A
229. Configure WLAN
service-based client rate
limiting.
client-rate-limit direction
{ inbound | outbound }
mode { dynamic | static } cir
cir
By default, WLAN service-based client
rate limiting is disabled.
Displaying and maintaining client rate limiting
Task Command Remarks
Display client rate limiting
information.
display wlan client-rate-limit
service-template
[ service-template-number ] [ | { begin |
exclude | include } regular-expression ]
Available in any view.
Client rate limiting configuration example
Network requirements
The fat AP is connected to Switch. Configure client rate limiting on the fat AP, so that fat AP limits the
incoming traffic in static mode and limits the outgoing traffic in dynamic mode for the clients.
Figure 32 Network diagram
Configuration procedure
# Create a WLAN-ESS interface.
<AP> system-view
[AP] interface wlan-bss 1