Priority mapping configuration examples, Trusted priority type configuration example, Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 35
26
Priority mapping configuration examples
NOTE:
•
The configuration examples were created on a WX5004 access controller and may vary with device
models.Check
to see where you configure Ethernet interfaces.
Table 7 Ethernet interface configuration prerequisites
Hardware
Ethernet interface configuration prerequisites
Access controller modules (installed in a switch)
LSQM1WCMB0
LSQM1WCMD0
LSBM1WCM2A0
LSRM1WCM2A1
LSRM1WCM3A1
You configure Ethernet interfaces on the switch.
NOTE:
To log in to the access controller module from the switch, use the oap connect
slot
slot-number
command.
LSWM1WCM10
LSWM1WCM20
You configure Ethernet interfaces on the switch.
NOTE:
To log in to the access controller module from the switch, use the oap connect
slot 1
slot-number
system
system-name
command.
Wireless switches
WX3024E
Use the oap connect slot 0 command on the access controller engine to log
in to the switching engine.
Access controllers
WX6103
Use the oap connect slot 0 command on the active main control board to log
in to the switch interface board.
WX5002
WX5004
You configure GE interfaces on the access controller.
Trusted priority type configuration example
Network requirements
As shown in
, the AC processes packets for AP 1, AP 2, and AP 3.
Configure the AC to enqueue packets according to their 802.1p priority and use the default priority
mapping tables for priority mappings.