H3C Technologies H3C WX5500E Series Access Controllers - Manual (Page 54)

46
Outputting system information to the SNMP module
The SNMP module receives the trap information only, and discards the log and debugging information.
To monitor device running status, trap information is usually sent to the SNMP NMS. For this purpose, you
must configure output of traps to the SNMP module, and set the trap sending parameters for the SNMP
module. For more information about SNMP, see "Configuring SNMP."
To output system information to the SNMP module:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable the information center. info-center enable
Optional.
Enabled by default.
3. Specify a name for a channel
identified by its number.
info-center channel
channel-number name
channel-name Optional.
See
Table 2 for default channel
names.
4. Configure an output channel
for the SNMP module.
info-center snmp channel
{ channel-number |
channel-name }
Optional.
By default, system information is
output to the SNMP module
through channel 5 (known as
snmpagent).
5. Configure an output rule for
the SNMP module.
info-center source { module-name |
default } channel { channel-number
| channel-name } [trap { level
severity | state state } * ]
Optional.
See "
Default output rules of system
information ."
6. Configure the timestamp
format.
info-center timestamp { debugging
| log | trap } { boot | date | none }
Optional.
The timestamp format for log, trap
and debugging information is date
by default.
Outputting system information to the Web interface
The Web interface receives log information only, and discards the trap and debugging information.
This feature allows you to control whether to output system information to the Web interface and, if so,
which system information can be output to the Web interface. The Web interface provides search and
sorting functions. You can view system information by clicking corresponding tabs after logging in to the
device through the Web interface.
To output system information to the Web interface:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enable the information center. info-center enable
Optional.
Enabled by default.