H3C Technologies H3C WX5500E Series Access Controllers User Manual
Page 96
88
Configuring the egress port for a remote source group
CAUTION:
Disable these functions on the egress port: spanning tree, 802.1X, IGMP snooping, static ARP, and MAC
address learning.
Either you can configure the egress port for a mirroring group in system view, or you can assign the
current port to it as the egress port in interface view. The two configuration methods lead to the same
result.
When you configure the egress port for the remote source group, follow these guidelines:
•
A mirroring group contains only one egress port.
•
A port of an existing mirroring group cannot be configured as an egress port.
To configure the egress port for a remote source group in system view:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure the egress port for
a remote source group.
mirroring-group group-id
monitor-egress monitor-egress-port
By default, no egress port is
configured for a remote source
group.
To configure the egress port for a remote source group in interface view:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A
3.
Configure the current port as
the egress port for a remote
source group.
mirroring-group group-id
monitor-egress
By default, a port does not serve as
the egress port for any remote
source group.
Configuring the remote probe VLAN for a remote source group
Before configuring a remote probe VLAN, create a static VLAN that serves as the remote probe VLAN for
the remote source group.
When you configure the remote probe VLAN for the remote source group, follow these guidelines:
•
A VLAN can serve for only one mirroring group.
•
When a VLAN is configured as a remote probe VLAN, you must remove the remote probe VLAN
configuration before deleting the VLAN.
•
When you remove the configuration of a remote probe VLAN, an active mirroring group becomes
inactive.
•
When a VLAN is configured as a remote probe VLAN, use the remote probe VLAN for port
mirroring exclusively. Do not configure a VLAN interface or any other features for the VLAN.
•
The remote mirroring groups on the source device and destination device must use the same remote
probe VLAN.
To configure the remote probe VLAN for a remote source group: