Grass Valley K2 Dyno PA Configuration Manual v.1.0 - Manual (Page 32)

Installing the Grass Valley platform service
Apart from the Browse feature, the Grass Valley platform service manages all the
interactions between the K2 Dyno PA application and the K2 system or systems. The
Grass Valley platform service can be obtained from the FTP download site.
Prerequisites:
• Grass Valley does not recommend the use of a firewall with Dyno PA. If using a
firewall, ensure that the port 49173 is allowed full access on the PC with the Grass
Valley platform service installed and all PCs running Dyno PA.
• The hardware and software requirements as specified in K2 Dyno PA Prerequisites.
• An administrator-level username and password for the K2 system that Dyno PA
communicates with.
• A PC that the service can be run on. Do not run the platform service on the K2
Media Client, K2 Product Client, or K2 Solo Media Server. The platform service
can be run on the same PC as the Dyno PA application.
To install the Grass Valley platform server, follow these steps:
1. Double-click the Dyno-PlSvc file.
2. Follow the installation wizard, and accept the EULA license.
The platform service is now installed.
3. After you install the platform service, reboot the PC or manually start the service.
The service is set to automatic.
4. Proceed to Installing the K2 Dyno PA application.
Related Links
Installing the K2 Dyno PA application on page 32
Starting the K2 Dyno PA application on page 36
Installing the K2 Dyno PA application
The K2 Dyno PA installation software can be obtained from the FTP download site.
Prerequisites:
• Grass Valley does not recommend the use of a firewall with Dyno PA. If using a
firewall, ensure that the port 49173 is allowed full access on the PC with the Grass
Valley platform service installed and all PCs running Dyno PA.
• The hardware and software requirements as specified in K2 Dyno PA Prerequisites.
• If using the Browse feature, follow the procedures described in Configuring the
K2 Summit system for K2 Dyno PA and then copy the FsNameServers file from
the K2 Summit system to the K2 Dyno PA machine. This file must be in the
C:\SNFS\Config folder on the Dyno PA as well as the K2 Summit system. Reboot
the Dyno PA machine before proceeding. For more information, see About K2
Summit and K2 Dyno PA DLC configuration.
32 K2 Dyno Production Assistant Configuration Manual 11 June 2010
Installing K2 Dyno PA