Grass Valley K2 Media Client Service Manual v.3.3 - Manual (Page 45)

June 25, 2009 K2 Media Client Service Manual 45
BIOS POST messages
Keyboard locked - Unlock key switch Unlock the system to proceed.
Monitor type does not match CMOS -
Run SETUP Monitor type not correctly identified in Setup
Shadow Ram Failed at offset: nnnn Shadow RAM failed at offset nnnn of the 64k
block at which the error was detected.
System RAM Failed at offset: nnnn System RAM failed at offset nnnn of in the 64k
block at which the error was detected.
Extended RAM Failed at offset: nnnn Extended memory not working or not configured
properly at offset nnnn.
System battery is dead - Replace and
run SETUP The CMOS clock battery indicator shows the
battery is dead. Replace the battery and run Setup
to reconfigure the system.
System CMOS checksum bad -
Default configuration used System CMOS has been corrupted or modified
incorrectly, perhaps by an application program
that changes data stored in CMOS. The BIOS
installed Default Setup Values. If you do not want
these values, enter Setup and enter your own
values. If the error persists, check the system
battery or contact your dealer.
System timer error The timer test failed. Requires repair of system
board.
Real time clock error Real-Time Clock fails BIOS hardware test. May
require board repair.
Check date and time settings BIOS found date or time out of range and reset the
Real-Time Clock. May require setting legal date
(1991-2099).
Previous boot incomplete - Default
configuration used Previous POST did not complete successfully.
POST loads default values and offers to run Setup.
If the failure was caused by incorrect values and
they are not corrected, the next boot will likely fail.
On systems with control of wait states, improper
Setup settings can also terminate POST and cause
this error on the next boot. Run Setup and verify
that the waitstate configuration is correct. This
error is cleared the next time the system is booted.
Memory Size found by POST differed
from CMOS Memory size found by POST differed from
CMOS.
Diskette drive A error Drive A: or B: is present but fails the BIOS POST
diskette tests. Check to see that the drive is defined
with the proper diskette type in Setup and that the
diskette drive is attached correctly.
Diskette drive B error
Incorrect Drive A type - run SETUP Type of floppy drive A: not correctly identified in
Setup.
Incorrect Drive B type - run SETUP Type of floppy drive B: not correctly identified in
Setup.
BIOS Message Description