Grass Valley K2 Media Client User Manual v3.3 - Manual (Page 186)

186 K2 Media Client User Manual June 5, 2009
Chapter 10 SDA-00: Audio/Video Configuration
DV compression format setup
To access record channel video settings, open Configuration Manager, click Channel ,
and select a record channel (R1, R2).
MPEG compression format setup
To access record channel video settings, open Configuration Manager, click Channel ,
and select a record channel (R1, R2).
For this setting... Configure as needed…
Compression
format DV25 Selecting one of these DV formats makes
settings available as documented in this table.
DV50 is a licensable option.
For other format settings, refer to
“MPEG
compression format setup” on page 186 and
“MPEG:D10 compression format setup” on
page 188
.
DV50
DVCAM
Input type SDI —
Analog Composite When the reference standard is NTSC and this
setting is selected, it makes the following
setting(s) available below:
Input pedestal
Input pedestal On If you are operating with a standard NTSC input
signal with 7.5 IRE setup, then make this
selection. You must make this selection for both
record channels.
Off —
Automatic VITC
detection On When selected, settings available below for
VITC lines are Starting VITC line and Ending
VITC line
Off When selected, settings available below for
VITC lines are VITC line 1 and VITC line 2
Starting VITC line
-or-
VITC line 1
NTSC: Between 10 and 20
PAL: Between 6 and 22
Ending VITC line
-or-
VITC line 2
NTSC: Between 10 and 20.
PAL: Between 6 and 22
VITC present Green LED indicates VITC is present.
Black LED indicates VITC is not present.
For this setting... Configure as needed…
Compression
format MPEG Selecting this format makes settings available
as documented in this table.
For other format settings, refer to
“DV
compression format setup” on page 186 and
“MPEG:D10 compression format setup” on
page 188
.