Grass Valley Kayenne XL Package v.7.0.4 - Manual (Page 109)

Kayenne XL Package — User Manual 107
Transition Control
Figure 71. Kayenne XL Transition Panel - Cut / Auto Buttons
Figure 72. Kayenne XL Transition Panel - Module Detail 15
Transition Elements
The Key 1 – 6 and BGD buttons select the elements that will change during
the next transition. Pressing these buttons does not change the current
output of the switcher, but prepares for a change (the next transition).
Pressing one transition element button automatically turns off the others in
this group. More than one transition element can be selected by holding
down one button while pressing another in the group. Elements not
selected remain in their current state when the transition is performed. For
example, if Key 1 is on and is not selected as part of the next transition, it
will remain on during and after the transition.
The BGD button selects a change in the background buses. The result will be
a transition from the current source on the PGM bus to the source selected
on the PST bus. After the transition, the buses will flip-flop, so the PGM bus
always remains the on-air bus. The PGM bus selection remains the back-
ground source if this button is not selected as part of the next transition.
The Key 1 - 6 buttons select the keyers that will be involved in the next tran-
sition. The keys currently visible on the output of the switcher are identi-
fied by the
On
indicator lights below each button. Note that a key may be on
but not visible (for example, half way through a preset black transition).
The Key Prior button selects a change in the key priority. The layering order
(stack) of the keys will transition from the current stack to a new stack spec-
Cut and Auto Transition for all selected components enabled/selected
for ”Next Transition”.
Transition Duration Rate (used by Auto) for selected components
enabled/selected for ”Next Transition”.