HEIDENHAIN iTNC 530 (340 49x-01) - Manual (Page 332)

332 8 Programming: Cycles
8.4 Cy
cles f
o
r Milling P
o
c
k
ets, St
uds and Slots
8 Machining operation (0/1/2) Q215: Define the
machining operation:
0: Roughing and finishing
1: Only roughing
2: Only finishing
Side finishing and floor finishing are only executed if
the finishing allowances (Q368, Q369) have been
defined.
8 Circle diameter Q223: Diameter of the finished
pocket.
8 Finishing allowance for side Q368 (incremental
value): Finishing allowance in the working plane.
8 Feed rate for milling Q207: Traversing speed of the
tool in mm/min while milling.
8 Climb or up-cut Q351: Type of milling operation with
M03.
+1 = climb milling
–1 = up-cut milling
8 Depth Q201 (incremental value): Distance between
workpiece surface and pocket floor.
8 Plunging depth Q202 (incremental value): Infeed per
cut. Enter a value greater than 0.
8 Finishing allowance for floor Q369 (incremental
value): Finishing allowance in the tool axis.
8 Feed rate for plunging Q206: Traversing speed of
the tool while moving to depth in mm/min.
8 Infeed for finishing Q338 (incremental value):
Infeed per cut. Q338=0: Finishing in one infeed.
X
Y
Q207
Q223
X
Z
Q201
Q206
Q202
Q338