HEIDENHAIN iTNC 530 (340 49x-01) - Manual (Page 574)

574 13 MOD Functions
13.2 Sof
tw
a
re
Numbers and Option Numbers
13.2 Software Numbers and
Option Numbers
Function
The following software numbers are displayed on the TNC screen
after the MOD functions have been selected:
„ NC: Number of the NC software (managed by HEIDENHAIN)
„ PLC: Number and name of the PLC software (managed by your
machine tool builder)
„ Development level: Development level of the software installed
on the control
„ DSP1 to DSP3: Number of the speed controller software
(managed by HEIDENHAIN)
„ ICTL1 and ICTL3: Number of the current controller software
(managed by HEIDENHAIN)
In addition, coded numbers for the options available on your control
are displayed after the abbreviation OPT:
No options active %0000000000000000
Bit 0 to bit 7: Additional control loops %0000000000000011
Bit 8 to bit 15: Software options %0000001100000011