HEIDENHAIN iTNC 530 (340 49x-01) - Manual (Page 625)

HEIDENHAIN iTNC 530 625
14.3 T
e
c
hnical Inf
o
rm
ation
Test Run graphics
Display modes Graphic simulation before a program run, even while another program is being run
„ Plan view / projection in 3 planes / 3-D view
„ Magnification of details
Interactive programming
graphics „ In the Programming and Editing mode, the contour of the NC blocks is drawn on
screen while they are being entered (2-D pencil-trace graphics), even while another
program is running
Program Run graphics
Display modes „ Graphic simulation of real-time machining in plan view / projection in 3 planes / 3-D
view
Machining time „ Calculating the machining time in the Test Run mode of operation
„ Display of the current machining time in the Program Run modes
Returning to the contour „ Mid-program startup in any block in the program, returning the tool to the calculated
nominal position to continue machining
„ Program interruption, contour departure and reapproach
Datum tables „ Several datum tables
Pallet tables „ Pallet tables (with as many entries as desired for the selection of pallets, NC programs
and datums) can be machined workpiece by workpiece or tool by tool
Touch probe cycles „ Calibrating a touch probe
„ Compensation of workpiece misalignment, manual or automatic
„ Datum setting, manual or automatic
„ Automatic workpiece measurement
„ Cycles for automatic tool measurement
Specifications
Components „ MC 422 B main computer
„ CC 422 or CC 424 controller unit
„ Operating panel
„ 15.1” TFT color flat-panel display with soft keys
Program memory „ Hard disk with at least 36 GB for NC programs
Input resolution and display
step „ To 0.1 µm for linear axes
„ To 0.0001° for angular axes
Input range „ Maximum 99 999.999 mm (3.937 in.) or 99 999.999°
User functions