Lanner LEC-3010 - Manual (Page 19)

17
Bios Settings
Chapter 4
Embedded and Industrial Computing
Option Description
Auto Set this value to allow the BIOS to auto detect
the DMA mode Use this value if the IDE disk
drive support cannot be determined This is the
default setting
SWDMA0 Set this value to allow the BIOS to use Single
Word DMA mode 0 It has a data transfer rate of
2 1 MBs
SWDMA1 Set this value to allow the BIOS to use Single
Word DMA mode 1 It has a data transfer rate of
4 2 MBs
SWDMA2 Set this value to allow the BIOS to use Single
Word DMA mode 1 It has a data transfer rate of
8 3 MBs
MWDMA0 Set this value to allow the BIOS to use Multi Word
DMA mode 0 It has a data transfer rate of 4 2
MBs
MWDMA1 Set this value to allow the BIOS to use Multi Word
DMA mode 0 It has a data transfer rate of 13 3
MBs
MWDMA2 Set this value to allow the BIOS to use Multi Word
DMA mode 0 It has a data transfer rate of 16 6
MBs
UDMA0 Set this value to allow the BIOS to use Ultra DMA
mode 0 It has a data transfer rate of 16 6 MBs
It has the same transfer rate as PIO mode 4 and
Multi Word DMA mode 2
UDMA1 Set this value to allow the BIOS to use Ultra DMA
mode 1 It has a data transfer rate of 25 MBs
UDMA2 Set this value to allow the BIOS to use Ultra DMA
mode 1 It has a data transfer rate of 33 3 MBs
UDMA3 Set this value to allow the BIOS to use Ultra DMA
mode 1 It has a data transfer rate of 44 4 MBs To
use this mode, it is required that an 80-conductor
ATA cable is used
UDMA4 Set this value to allow the BIOS to use Ultra DMA
mode 1 It has a data transfer rate of 66 6 MBs To
use this mode, it is required that an 80-conductor
ATA cable is used
UDMA5 Set this value to allow the BIOS to use Ultra DMA
mode 1 It has a data transfer rate of 99 9 To use
this mode, it is required that an 80-conductor
ATA cable is used
UDMA6 Set this value to allow the BIOS to use Ultra DMA
mode 1 It has a data transfer rate of 133 2 MBs To
use this mode, it is required that an 80-conductor
ATA cable is used
S.M.A.R.T. for Hard disk drives
Self-Monitoring Analysis and Reporting Technology
(SMART) feature can help predict impending drive
failures The Load Optimal default setting is Auto