Lanner LEC-3010 - Manual (Page 7)

5
Introduction
Chapter 2
Embedded and Industrial Computing
Note:
SO-DIMMs installed should meet the required 1
speed which is 667 MHz Do not install SO-DIMM
supporting different speeds
The motherboards can support up to 2 GB 2
memory capacity in maximum
Installing a CompactFlash Card
LEC-3010 provides one CompactFlash slot Follow the se
procedures bellow for installing a CompactFlash card
Unscrew the thumbscrew on the CF slot to take out 1
the front cover
Align CompactFlash and the card slot with the arrow
2
on the CompactFlash pointing toward the connector
Insert the CompactFlash into the connector
3
Close the cover and fasten it with thumbscrew to the 4
slot
Note: The device has error proof design so that it
won’t be inserted if it is in the wrong orientation
You should insert the CF card with its cutout facing
up and arrow on the CompactFlash pointing
toward the connector
1
2 3
Chapter 2:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from the
server The front panel Power On/Standby button
does not completely shut off system power
Portions of the power supply and some internal
circuitry remain active until AC power is removed
Unpower the LEC-3010 and remove the power cord 1
The top cover has a horse shoe shape Unscrew the 2
3 threaded screws at the top and the bottom of the
opposite side and 2 from each side of the LEC-3010
System
Slide the cover backwards to open the cover
3
upwards
Installing the System Memory
The motherboard supports DDR2 memory that features
data transfer rates of 667 MHz to meet the higher
bandwidth requirements of the latest operating system
and Internet applications It comes with one Double Data
Rate(DDR2) Small Outline Dual Inline Memory Module
(SO-DIMM) socket
Align the memory module’s cutout with the SO-DIMM 1
socket’s notch
Install the SO-DIMM
2
4
Cutout
Notch